Reval Configuration

Select the Configuration tab to set up your Reval Units.

Configuration / IDPoint Map

These configuration settings are used to map the IDPoints in your Reval Units to the FasTrak Reval service.

IDPoint — Enter an IP Address for the IDPoint. Note that each IDPoint requires its own IP Address.

Subnet Mask — Enter the Subnet Mask for the IDPoint.

Default Gateway — Enter the Default Gateway for the IDPoint.

Card Option — If cards are to be used as a method of user identification, select whether they are in hexadecimal or decimal format. This selection will depend on which setting has been selected for cards in ID Manager.

Audio Confirmation — Tick this checkbox to enable an audible sound from the IDPoint when a user is identified.

Rotate Scanner — This option should be used if better identification results are received when using the fingerprint scanner upside down. This may be the case when fingerprints have been enrolled on a scanner configured to use a different orientation.

Click Update to update the mapping selections.

Remove — Click this button to remove a mapped IDPoint. Note that this doesn't remove the selection entirely; only removes any mapping configuration you have applied to it.

For information on configuring and installing an IDPoint licence, view section 3.0 – IDPoint Setup. To test an IDPoint, view section 3.3 – Testing an IDPoint.